Blasting & Painting
Paint found on new valves is just a temporary coating, designed to delay exterior corrosion while the valve is in storage
or until the final paint or coating is applied to the entire piping system after installation.
How Can We Help?
Coating specifications consist of three parts that constitute the complete coating process. They are, Pretreatment
and surface preparation, Paint or coating application and Paint or coating curing. A paint or coating is transformed
into a solid paint film through the curing process. This curing may occur at room temperature or in an oven.
Proper surface preparation is critical for the successful application of any coating.
Our Services
Surface Preparation
- Proper surface preparation is critical for the successful application of any coating. The surface may
be prepared either chemically or mechanically. The chemical preparation process yields an etched surface
to give more bite to the coating to be applied. Mechanical surface preparation involves removing surface
imperfections by water or dry-blasting techniques. Different paints require different surface finishes
to adhere properly.
Types of Coatings Used
- Arcylic
- Alkyds
- Epoxy
- Epoxy
Choosing the Right Coatings
- Concerns what the coating will be exposed to such as :
- i.) Are chemical fumes close by?
- ii.) What is the operating temperature?
- iii.) Are chemical splashes or spills likely?
- iv.) Will the coating be covered with insulating materials?
- v.) Will the coating be cleaned, and what cleaning process and chemicals will be employed in the cleaning process?
- vi.) Will the coating be applied over an existing coating?
How It Work?
1
Consult
We receive your inquiries,
get to know your needs and requirements.
2
Plan
We will start planning and drafting
the proper equipments and procedures
for the project.
3
Execute
The project will be executed on your
request until job completion.
